Capture images in a sequence
The sequence mode is available only in the main camera.
To set the camera to capture images in sequence (if
enough memory is available), in the active toolbar, select
Sequence mode
.
To start capturing images in a quick sequence,
select
Burst
, and press and hold the capture key. The
device captures images until you release the key or until
the memory runs out. If you press the capture key briefly,
the device captures six image in a sequence.
To capture two or more images in defined intervals, select
the desired time interval. To capture the images, press
the capture key. To stop capturing images, select
Cancel
. The number of images taken depends on the
available memory.
The captured images are shown in a grid on the display.
To view an image, press the scroll key. If you used a time
interval, only the last captured image is shown on the
display.
You can also use the sequence mode with the self-timer.
To return to the sequence mode viewfinder, press the
capture key.
To switch off the sequence mode, in the active toolbar,
select
Sequence mode
>
Single shot
.